Want an Even Flooring? A Step by Step Guide to Use Liquid Latex flooring
If you have uneven floors at home, a self-leveling liquid latex flooring can solve your problem without costing you a lot. This process is usually followed before tiling, painting, painting, or carpet installation of a subfloor. Before you start with your liquid latex flooring, you have to identify the dips on your clean it properly, then start applying your liquid latex flooring solution as instructed below. Liquid latex only takes a day to dry completely, so it’s convenient to continue with your project without any delays.
Now, let’s start with our guide on how to get perfect liquid latex flooring. Make sure to read it through completely and apply yourself.
Assess Your Floor
To start with liquid latex flooring, remove the existing tile or carpeting if any. Examine the subfloor now. If the floor is concrete, remove away the rugs and furniture above it. Use a utility knife to cut the grout and lift up each piece of tile with the help of a chisel. To remove the carpet, also use a utility knife to cut off pieces and remove it using a pry bar.
Check the Floor with a Level
Well, you must have known how to use a level. Place the level in different areas where you suspect the floor is uneven. You have to remember that latex screed will work best on dips not more than 2–3 inches lower than your original floor.
Use a Straightedge
You have to use a straightedge across the floor. If it tips to one side, then your floor must have a bump in it. If you notice a gap in between your straightedge and floor, then it’s clearly dipping in that area.
Clean the Floor
Now scrape off the floor from any residue. If there is mortar, glue, or residue, then remove it with the help of a scraper. After that, sweep up any leftover dirt. Now, vacuum the place well to remove the remaining dirt or dust. You can also use a wet sponge to wash the place away and let it dry completely before you use liquid latex flooring.
An Extra Step for Wooden Floors
If you have a wooden subfloor, you just can’t use the self-leveling liquid latex flooring compound above it. Use a metal lath over the floor first. It’s easily available at hardware stores. Remember, the self-leveling latex flooring compound can only be applied directly on concrete, HardieBacker floors, or cement board.
Time to Apply the Liquid Latex
Take a bucket to mix your liquid latex. Most of the liquid latex flooring compound has two compounds; dry mortar mix and a liquid latex solution. Only mix the compound if you are completely ready to cover that on the floor. Mix the compounds as per your requirement with the mentioned guides by the manufacturer. If you want to cover all your floor with liquid latex flooring, then start pouring the mixed compound right from the corner and slowly make your wart towards the door. By following this, you do not have to step over the wet latex and ruin it. You can further smooth up the floor by using a screed, a flat, long tool used to make mortar even. Make sure to fill all the dips present on your floor.
Time to Wait
That’s it. Let the liquid latex flooring compound dry for at least a day for the best results. Check with a gloved finger or use a dry stick to see the results. Now, reapply the tile, vinyl, carpet, or paint as per your wish.
A DEPENDABLE, LLC, we are renowned for manufacturing and supplying high-quality patching, underlayment, and floor preparation products, including liquid latex flooring and more to clients with the best price. We have been serving this niche since 1951 and well-trusted among customers for our best products. Browse our website today to place your orders or call at 800 227 3434 for more help.
